Course info

EE- 527P ( Practicum on analysis and design of power electronics converters)

Experiment-1: Familiarisation with the component in the power electronics lab, and Lt. spice exercise for 4 basic circuit topology. (Performed on 9th august)

Experiment-2: Buck converter (Performed on 16th august) 

Experiment-3: Boost converter (Performed on 23rd august)

Experiment-4: Half-bridge and full-bridge converter (Performed on 30 august, 6th September, 13th September)

Experiment-5: Introduction to sensors, signal conditioners & Single-phase H-Bridge converter with unipolar and bipolar pulses from IR2110 & Sinusoidal pulse width modulation to single-phase H-Bridge converter (Performed on  20 September,27 September & 4 October)

Experiment-6: Grid-connected bidirectional single-phase voltage source converter (performed on 11th October)

Experiment-7:  A three-phase sine PWM voltage source inverter and verification of harmonic spectrum table, with three-phase induction motor as a load. (performed on 25th October)

Experiment-8: A three-phase space vector PWM voltage source inverter and verification of the harmonic spectrum table with the help of three-phase induction motor as a load (performed on 1 November)

Experiment-9 Active power filter application by using an indirect current control technique (performed on 8 November)

Experiment- 10